Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
Check area above installation location to be sure that wiring can run to the planned location and that
Inspect duct work and wiring before proceeding with installation.
Before installation, provide inspection and future maintenance access at a location that will not interfere
with installation work.
Do not attempt to install this fan in a wall or vaulted ceiling. This fan is for standard horizontal ceiling
installation only.
You may need the help of a second person to install this fan: one person on the attic side and one on
the room side.
Tools required for assembly (not included): Electric Drill, Drill Bits, Phillips Screwdriver, Utility Knife
Other supplies you will need (not included): Duct Tape
Note: Installations may vary depending on how the previous bath fan was installed. Supplies necessary
for the installation of your bath fan are not all included; however, most are available at your local
home improvement or hardware store.
DIMENSIONS
Ceiling
Opening (L)
7-1/2 in.
WIRING DIAGRAM
LIGHT HOUSING
LED Night Light
LED Light
Automatic
terminal
switch
Capacitor for
long life of
MOTOR
motor
FAN HOUSING
Ceiling
Opening (W)
7-3/4 in.
to 120V/60Hz
Junction
Box
Orange wire
to switch
White wire
to neutral
Blue wire
to switch
White wire
to neutral
Black wire
to switch
White wire
to neutral
Green wire
to ground
5
QUICK CONNECTOR INSTRUCTIONS
To be sold only with installation instructions.
WARNING: Wiring must comply with all appliable
electrical codes. Turn OFF power before removing or
installing connectors.
WARNING: COPPER TO COPPER ONLY. Do not use
aluminum wire.
CAUTION: Accessory part (quick connector) should
meet installation instructions below.
NOTE: The connector is reusable on solid wires of the
same wire gage or smaller. Do not reuse the connector
on stranded wires.
• Strip wires 3/8 in. - 1/2 in.
• rip the wire firmly and push the stripped end of the
G
wire into the open port of the connector. Use only one
conductor per port.
•
V
r e
y f i
h t
e
s
r t
p i
p
e
d
e
n
d
f o
h t
e
i w
the back of the connector.
House
wires
NOTE: Important wire information. Maximum temperature
rating
F
. 600 volts maximum for building wire
and 1,000 volts maximum for building wire and 1,000 volts
The acceptable wire range includes: Solid: 12-18 AWG.
e r
s
s i
l u f
ly inserted to
Quick
connect
Product
wires
Publicidad
