Publicidad
Idiomas disponibles
Idiomas disponibles
1. Press the shaft lock button, hold down and rotate the shaft by hand until it
engagesthe shaft lock. Do not engage the shaft lock button while multitool
is running.
2. Press the shaft lock button, hold down and rotate the shaft by hand until it
engagesthe shaft lock. Do not engage the shaft lock button while multitool
is running.
3. Remove the collet by pulling it free from the shaft.
4. Install the appropriate size collet fully into the shaft and reinstall the collet
nut finger tight. Do not fully tighten the nut when there is no bit or
accessory installed.
1. Press the shaft lock button and rotate the shaft by hand until it engages the shaft lock. Do not engage the shaft lock button while multitool is running.
2. With the shaft lock button engaged, loosen (do not remove) the collet nut. Use the collet wrench if necessary.
3. Insert the bit or accessory shank fully into the collet.
4. With the shaft lock button engaged, finger tighten the collet nut until the bit or accessory shank is gripped by the collet.
NOTE: Be sure to read the instructions supplied with your DEPSTECH accessory for further information on its use.
Use only DEPSTECH tested, high performance accessories.
Changing Collets
E
A
D
Changing Accessories
09
B
Wrench
A
Shaft lock button
B
C
Collet nut
To loosen
D
C
E
To tighten
Publicidad
