Buffalo 600 Serie Manual De Instrucciones página 5

Electrical wiring
There is a danger to life if the wires are incorrectly connected.
Connection to a suitable power supply should only be carried out by a qualified and
competent electrical engineer.
Warning: The fixed wiring of the power cord connection must be equipped with a
disconnect device (leakage protection switch) with a contact distance greater than 30mm
according to the wiring rules.
Connect the unit in accordance with the applicable regulations of your country, federal state, city or local
authority.
Connect the unit to a standard energy supply network.
For a proper electrical connection, adjust the power ratings to the local circumstances and requirements.
Equipotential bonding terminal in electrical appliances is to connect exposed metal and conductive
parts of electrical devices and other devices in electrical appliances with artificial or natural grounding
conductors to reduce potential differences (reduce and prevent the risk of electric shock).
• This appliance is supplied unplugged and require hardwiring to a suitable electrical power supply.
CU473 and CU474 requires a 3kW 230V one-phase circuit at 50Hz
CU475 requires a 4.5kW 400V three-phase circuit at 50Hz
• Connect the wires correctly according to their colour coding. This appliance is wired as follows:
Wire colour
Yellow/green
Blue
Brown, grey and black
• The appliance must be earthed. If in doubt consult a qualified electrician.
• Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Assembly
This appliance is fitted with adjustable feet to enable the unit to be positioned securely and level. This
should be carried out on completion of the electrical connection. Refer to the 'Electrical wiring' section as
above. No further assembly is required.
Note: Before using for the first time, clean all parts well. Let dry completely.
Before first time use
Before using for the first time the cooking surface needs to seasoned.
1. Ensure the cooking surfaces are clean, then brush the surfaces with cooking oil.
2. Turn the appliance On at the mains power supply and set the thermostat to 110°C. The heating
indicator light turns on.
3. When the set temperature is reached, the Heating indicator light turns Off.
4. Turn the appliance Off and allow it to cool before wiping away any excess oil.
5. The appliance is now ready to use.
CU473-CU474-CU475_ML_A5_v2_20240202.indb 5 CU473-CU474-CU475_ML_A5_v2_20240202.indb 5
DANGER of electric shock from incorrect connection
Wire function
Earth wire, protective conductor
Neutral wire, neutral conductor
Live wires, Phase L1, L2, L3
To terminals of power supply
Terminal marked E
Terminal marked N
Terminal marked L1, L2, L3
EN
5
2024/2/2 17:05 2024/2/2 17:05