neno Camino Manual Del Usuario página 18

• The breastshield should be replaced every 6 months if you use the breast-
pump more than 3 times a day.
• Replace the tube only if moisture gets into the tube or if it is damaged.
10. MILK PREPARATION
1. Do not thaw frozen milk in the microwave or in boiling water. This can burn
the baby's mouth.
2. Thaw the milk in the fridge overnight. Do not freeze thawed milk again.
3. You can quickly thaw the milk, keeping it under running water at a tempera-
ture of max. 37 °C. Place the closed bottle/bag in a bowl of warm water for
20 minutes to bring the milk to body temperature.
4. Do not add freshly expressed milk to previously frozen milk if the amount of
fresh milk exceeds the amount of milk previously frozen. Feeding:
a. It is recommended to breastfeed before you start feeding your baby
with a bottle.
b. Always check the bottle, teat and other components before and after
each feeding. If the teat is damaged, stop using it immediately.
c. To avoid a choking hazard, test the strength of the teat by gently pulling
the protruding part of it.
d. Do not attempt to enlarge the hole in the teat.
e. Infants should not be bottle fed without adult supervision.
f. The bottle teat should not be used as a pacifier.
11. FAQ
The device does not start:
Make sure that the breast pump is connected to a working power outlet. If the
lactator does not have any power source, its display will not turn on and no error
message appears.
The device does not pump when turned on:
Make sure the device has a charged battery or is plugged in.
No/weak suction:
Make sure all breast pump components are positioned correctly. Disassemble
the breast pump and make sure that all components are clean and undamaged.
Assemble the breast pump again according to the instructions in the ASSEMBLY
section. During pumping, make sure that the entire surface of the breast shield
touches your breast.
More milk has flowed out of the breast than the bottle can hold:
Turn off the breast pump and unplug it from the power supply. Use a moist (not
wet) cloth to wipe the breast pump. Wash the device components in which the
milk is located, according to the instructions in the CLEANING AND DISINFECTION
section. When all the components of the device are dry, assemble the device again.
18