Lorelli RIBERA Instrucciones De Uso página 6

24. Do not add an extra mattress / pad.
25. The stroller is intended for use by children up to 3 years old!
26. The bumper bar cannot be used as a carrying handle!
1. To clean the metal parts, wipe with a damp cloth and dry thoroughly with a dry cloth.
2. To clean the plastic parts, use a cloth, water and mild detergent.
3. To clean the textile parts, use an upholstery cleaner.
4. When the stroller is in storage never place other items on top of it.
5. Always dry and air out the stroller if it gets wet!
6. Periodically clean the wheel axles and plastic elements.
7. Always clean the axles of the wheels and the plastic elements after using the stroller on sand or other dusty surfaces!
8. DO NOT GREASE the wheel axles or other moving parts of the stroller! Clean them only!
9. Periodically check for loose or damaged parts and if there are any, immediately replace them with new ones!
Picture A
1. Canopy - 1 pc.
2. Bumper bar
3. Footrest
4. Front wheels
5. Handle
6. Rear wheels
1. Install the rear wheels by inserting them into the holes on the rear axle (Picture 1). Ensure that they are securely locked in
place. To remove, press the button on the console and pull the wheel (Picture 1).
2. Unfolding the stroller - lift the handle up, the stroller will unfold and lock in place automatically. (Picture 2)
1. Adjusting the backrest - To raise the backrest, squeeze the buckle button at the back and pull the strap (Picture 3). To
release the backrest, press the button on the buckle and slide it down (Picture 4).
2. When using the seat, it is MANDATORY to put the child's safety harness on! Attach the shoulder and abdominal straps and
place them in the central buckle until you hear a click (Picture 5). Adjust the length of the harness straps by pulling on the
loose ends. To release the harness, press on the central buckle button (Picture 6).
3. To park the stroller in place, use the parking device on the rear wheels by pressing the pedal located on the rear axle
(Picture 7). To release the parking device, push the top of the pedal forward (Picture 7).
4. Remove the cover as shown in (Picture 8). Before placing the child in the stroller, press the button on one end on the inside
of the bumper bar and open it (Picture 9), after placing the child in the stroller, secure the bumper bar again. Removing the
bumper bar, press the buttons on both sides and pull.
5. To adjust the canopy - grab its upper part and pull it down to the desired position. (Picture 13, 14) Folding the canopy - pull
it towards the handle (Picture 10).
6. Adjusting the footrest - to change the position of the footrest, press the buttons on both sides of the seat simultaneously and
adjust to the desired position (Picture 11)
ATTENTION! Failure to observe this instruction will damage the locking mechanisms and will not be subject to
warranty!
1. Fold the canopy as much as possible.
2. Slide the button "1" (Picture 12) from right to left and hold it to release the lock, then press the second button from the
bottom "2" and push the handle down (Picture 13). Push the handle inward so that it is folded against the chassis (Picture 14).
Grasp the transport handle and pull it up (Picture 15).
Removing the front wheels.
1. To remove the front wheels, remove the protective cap (Picture 16, 17), then unscrew the bolt (Picture 18) and pull the wheel
down.
CARE AND MAINTENANCE
PARTS
- 1 pc.
- 1 pc.
- 2 pcs.
- 1 pc.
- 2 pcs.
ASSEMBLING THE STROLLER
FOLDING THE STROLLER
USE