4.2. Diagrama panel frontal
Adjustment of
inductance
and P number
IMPORTANT:
To select the program number, rst choose the working mode, using the key (4), wait for it to ash
(Save) and press (4) again, choose the number using the knob (3).
For the functions in the following table, use the (4) and (5) key. To change the values of each parameter,
use the knob (3).
Start using equipment with "ARL" at 0 and "ind" at 0, modify slightly on this basis.
Voltage display
Current display
(1)
Adjustment
percentage of
the selected
synergic curve
07
ON/OFF indicator
Overheating indicator
(4)
(3)
(5)
(2)
SWEISSWELD.COM
Power setting (SYN-ON) or
wire speed (SYN-OFF)
Mode and P
selection
Parameter
selection