Important - ANEXO SPEED PRO Manual De Usuario

COOLER UNIT (70)
Place the cooler unit in its housing in the stand (Figure 6).
Mount the components as indicated in Figure 19 in this order.
Mount the piston-gasket and the lever in the tank following the steps indicated in the
enclosed drawing.
Fit the tank.
Adjust the pump lid inside the tank with the arrow pointing towards you.
Secure the metal coupler plate, securing the tank with it.
SS/TANK STAND (90), COOLER STAND (100)
Machine placement on display stand:
IMPORTANT: This operation must be carried out by 2 or 3 people. It must never be attempted
by just one person.
Lock the front wheels of the stand with the brake pedal to prevent it from moving during the
installation.
After unpacking the stand, remove the screws from the fixing brackets and put them on one
side for later. See detail "A" of Figure 8.
The peel chutes and the drip tray of the stand with filter are located on the inside of the stand.
Place the machine on the stand, making the inside corners of the machine base coincide
with the two rubber blocks of the stand. Thus, the fixing bracket holes will coincide with
the machine holes. You can now secure the machine with the screws mentioned above (See
Figure 5 or 6).
Remember:
The machine and display stand are joined together with the screws supplied, as indicated in
this instructions manual.
Never try to tilt the machine or the stand. To move, unlock the wheels.