AFG PRO 7.2 Ai Manual Del Propietário página 10

ASSEMBLY STEP 1
HARDWARE FOR STEP 1 • PRE-INSTALLED
PART TYPE
F BOLT
G FLAT WASHER
H SPRING WASHER
4
F
H
G
10
DESCRIPTION
M10X1.5PX20L
10.5X18X2.0T
10.2X18.4X2.5L
5
6
NOTE:
All hardware for this step is pre-installed. To avoid
QTY
scratches during assembly do not remove plastic from
4
tubes until STEP 4. We also recommend covering the base
4
rail with extra plastic sheet from the packaging.
4
Carefully pull the CONSOLE CABLE (4) through the
A
CONSOLE MAST (5) using the twist tie located inside
the CONSOLE MAST (5).
Attach the CONSOLE MAST (5) to the BASE FRAME
B
(6) using the pre-assembled 4 BOLTS (F), 4 SPRING
WASHERS (H) and 4 FLAT WASHERS (G)
NOTE: Be careful not to pinch any wires while attaching the
console mast or console.