Publicidad
Idiomas disponibles
Idiomas disponibles
• Clean the product and perform full servicing before
long-term storage.
• Use transportation guards on the product to prevent
injury or damage during transportation and storage.
• Securely stow the product during transport to ensure
safe handling.
7.2
DISPOSAL OF THE BATTERY, BATTERY
CHARGER, AND PRODUCT
Symbols on the product or the package of the product
mean that the product is not domestic waste. Recycle
it at a recycling station for electrical and electronic
equipment. This helps to prevent damage to the
environment and persons.
Get in touch with your local authorities, domestic waste
service, or your dealer for more information about how
to recycle your product.
8
TROUBLESHOOTING
Problem
Possible
Cause
The prod-
No electrical
uct does
contact be-
not start
tween the prod-
when the
uct and the bat-
trigger is
tery.
pulled.
The battery is
depleted.
The safety-lock
button and trig-
ger are not op-
erated at the
same time.
The prod-
The guard is
uct stops
not attached to
when you
the trimmer
are cut-
head.
ting.
Cutting line is
too heavy.
The grass be-
comes tangled
around the mo-
tor shaft or the
trimmer head.
English
Solution
1.
Remove battery.
2.
Inspect the metal
contacts and re-
insert the battery.
Charge the battery
pack.
1.
Push the safety-
lock button and
hold it.
2.
Pull the trigger to
start the product.
Remove the battery
and attach the guard
to the trimmer head.
Use only with the
nylon cutting line of
0.095" (2.4 mm) diam-
eter.
1.
Stop the product.
2.
Remove the bat-
tery.
3.
Remove the
grass from the
motor shaft and
trimmer head.
Problem
Possible
Cause
The motor is
overloaded.
The battery or
product is too
hot.
The battery
pack is discon-
nected from the
product.
The battery
pack is deple-
ted.
The cut-
Lines are inter-
ting line
locked.
does not
extend.
Not enough line
on spool.
Lines are worn
too short.
Lines are tan-
gled on spool.
The cut-
The product is
ting line
used incorrectly.
keeps
breaking.
13
Solution
1.
Pull the trimmer
head away from
the grassy area.
2.
Allow the prod-
uct to cool for at
least 10 minutes.
3.
Cut in stages
and guide the
trimmer head in
and out of the
grass, making
sure not to cut
more than 8" per
pass.
1.
Allow the battery
or product to
cool for at least
10 minutes. Re-
move the battery
from the product
to help the prod-
uct cool down
more quickly.
Install the battery
again.
Charge the battery
pack.
1.
Remove the in-
terlocked lines.
2.
Rewind the lines.
Install more line.
1.
Remove the bat-
tery.
2.
Press and hold
the bump head.
3.
Pull out lines
manually.
1.
Remove the
lines from the
spool.
2.
Wind the lines.
1.
Cut with the tip
of the line, avoid
stones, walls,
and other hard
objects.
EN
Publicidad
