EN
Problem
Possible
Cause
The grass
Grass too high.
becomes
tangled
around
the trim-
mer head
and motor
housing.
The cut-
The string cut-
ting line is
off blade be-
improper-
comes dull.
ly cut.
Too much
The line is worn
vibration.
down at one
side and not ad-
vanced in time.
The trimmer
head is worn
down.
The line has run
out.
9
TECHNICAL DATA
Type
Motor
No load speed
Cutting line diameter
Cutting width
Line feeding system
Battery model
Charger model
English
Solution
2.
Advance the cut-
ting line regularly
to keep full cut-
ting width.
1.
Cut in stages.
2.
Cut no more
than 8" in each
pass to prevent
tangling.
Sharpen the string
cut-off blade with a file
or replace it.
Make sure that the
line on both sides is
not damaged. Extend
the line.
Replace with a new
trimmer head.
Install more line.
Cordless, battery pow-
ered
60V Brushless
5000/6000 ± 10% RPM
0.095" (2.4 mm)
14 in. / 16 in. (35.6 cm /
40.6 cm)
Bump Feed
LB60251 / LB6041 /
LB6042 / LB6051 /
LB6081 and other BAC
series
CAC801 / CH60R00 /
CH60DP01 /
CHDPC10A and other
CAC series
The recommended ambient temperature range:
Condition
Product storage
Product operation
Battery charging
Charger operation
Battery storage
Battery discharging
10
LIMITED WARRANTY
BATTERIE • GARANTÍA PARA
HERRAMIENTAS Y BATERÍAS
Greenworks hereby warranties this product, to the
original purchaser with proof of purchase, for a period
of four (4) years against defects in materials, parts
or workmanship. Greenworks, at its own discretion
will repair or replace any and all parts found to be
defective, through normal use, free of charge to the
customer. This warranty is valid only for units which
have been used for personal use that have not been
hired or rented for industrial/commercial use, and
that have been maintained in accordance with the
instructions in the operator manual supplied with the
product from new.
ITEMS NOT COVERED BY WARRANTY:
1.
Any part that has become inoperative due
to misuse, commercial use, abuse, neglect,
accident, improper maintenance, or alteration; or
2.
The unit, if it has not been operated and/or
maintained in accordance with the operator
manual; or
3.
Normal wear;
4.
Routine maintenance items such as lubricants,
blade sharpening;
5.
Normal deterioration of the exterior finish due to
use or exposure.
HELPLINE:
Warranty service is available by calling our toll-free
helpline, at 1-855-345-3934.
TRANSPORTATION CHARGES:
Transportation charges for the movement of any power
equipment unit or attachment are the responsibility of
the purchaser. It is the purchaser's responsibility to
pay transportation charges for any part submitted for
14
Temperature
32°F (0°C) - 113°F (45°C)
32°F (0°C) - 113°F (45°C)
39°F (4°C) - 104°F (40°C)
39°F (4°C) - 104°F (40°C)
32°F (0°C) - 113°F (45°C)
32°F (0°C) - 113°F (45°C)
GARANTIE OUTIL &