Publicidad
Idiomas disponibles
Idiomas disponibles
Sauna/SANARIUM
7.
System settings
7.2.
Service menu (01) - CODE, code number
Requirement:
The controller must be switched on and in standby mode. There should be no programs
running.
Call up the service menu
1.
Press the four symbols (1, 2, 3, 4) one after
the other.
Pressing the correct positions on the
touchscreen will call up the service
menu even if the symbols are not
displayed.
.
Enter code number 7452 (5) to call up the
service menu.
2.
Enter each individual code digit by pressing
the +/- symbols (6) and confirm each one
by pressing the OK symbol (7).
Once the correct four-digit code has been entered,
the service menu is displayed together with the
symbol (8).
Press one of the symbols (9) to directly select the
corresponding service menu, e.g. 04 (10).
The service menu can also be selected using the
+/- symbols (6).
Display a selected service menu (10) by pressing
the OK symbol (7).
Example: Service menu 04
d
(10) Service menu number (selectable)
d
(11) Service menu name (display)
d
(12) Stored setting
1 Hz = selectable
2 Hz = display
d
(13) Storage cell (display).
Exit the service menu
Select the last service menu (END) and exit by
pressing the OK symbol.
The controller automatically exits the service menu and switches to standby mode after
more than 60 seconds of non-use.
Changes within a service menu that were not previously confirmed by pressing OK will
not be applied.
50701290/12.14
7
1
4
9
11
10
8
5
6
2
3
12
13
PAGE 21
Publicidad
