Gentherm Gelli-Roll 193P Instrucciones De Uso página 4

Maintenance and service activities will sometimes overlap. In general, maintenance refers to any activity that does not require a
certified technician. Maintenance may be performed by healthcare personnel or by other trained persons.
The following actions are considered maintenance:
1. Inspecting, cleaning, and disinfecting pads, and hoses.
2. Replacing hoses, other accessories.
Service refers to any activity that requires a Medical Equipment Service Technician, Certified Biomedical Electronics Technician, or a
Certified Clinical Engineer.
The following actions are considered service:
1. Repair of Gel Pad.
2. Replacing hoses, and other accessories.
3. Other Repairs.
For repair of the Gel Pad Only. Using Resurfacing Roll provided:
Do not attempt to resurface any product that has multiple damaged areas, deep punctures, gouges, large cracks or tears, or areas where
polymer has become dislodged. Items like this should be discarded and replaced.
1. Area to be resurfaced must be clean and dry before applying clear tape.
2. Any sticky surface exposed at damaged area may be removed with cleaning agent or warm, soapy water. Dry surface completely
before applying clear tape.
Measure damaged area and cut tape to size. Allow 0.25" overlap on all sides.
3.
4. Carefully peel back approximately one-half of brown release paper and crease it.
5. Carefully apply exposed portion of clear tape to damaged surface. Push out any air bubbles, that may be trapped beneath the tape.
6. Continue to carefully apply clear tape while slowly removing paper backing. Attempt to push out any air bubbles that develop.
If a fold / kink is observed in the internal pad:
®
1. Lay the Gelli-Roll flat on a solid surface.
®
2. Hold the Gelli-Roll by the foot of the pad.
3. Gently shake the Gelli-Roll
•
Always handle Gelli-Roll
corners may stretch the outer skin, causing stretch marks or tears. Pads should be rolled and cradled (like a baby) when lifted or carried.
Carrying them unsupported can stretch the outer skin and cause undue stress that may result in splitting. Carts can be used for larger
pads. These products are constructed to existing standards of quality control and should be usable for long periods with proper care.
•
Pads should be stored in a dry area, in flat or rolled position (never folded). Keep pads out of direct sunlight. Keep cabinet
doors and other sharp objects from coming in contact with pad surfaces at all times.
MAINTENANCE AND SERVICE
(Use GENTHERM Resurfacing Roll #169 included with pad)
®
like a small carpet until the fold / kink is removed.
®
pads carefully. Never tear them away from the bed, stretcher, or OR table. Lifting the product from the
Level I Repair
Other Repair
STORAGE
Page 4 of 28