Publicidad
3
GRINDER DESCRIPTION
1. Lid hopper
2. Coffee beans hopper
3. Regulation knob
4. Power button
5. Filter-holder fork
6. Micro-switch
FIRST-TIME INSTALLATION
3.1
Remove the knob locking screw with the allen-key (Fig.1).
•
Remove the knob forcefully by pulling it upwards (Fig.2).
•
Remove the logo on the back and, with a Philips screwdriver, unscrew the screw on
•
the back (Fig.3).
Remove the gasket (Fig.4) and then remove the lid by sliding it sideways first, and
•
then upwards (Fig.5).
Remove the 4 transport securing screws using a Philips screwdriver (Fig.6).
•
•
Reassemble the lid and the knob paying attention to keep the o-ring in its seat.
To use the equipotential bonding socket (11), connect the outer conductor by
•
unscrewing the two screws of the terminal (Fig.9). Insert one end of the conductor
and retighten the screws.
PRELIMINARY OPERATIONS
3.2
Before starting to work, the appliance must be adjusted according to the type of coffee blend
and the desired degree of grinding.
Insert the coffee bean hopper (2) in its seat paying attention to the hopper closing tap
•
(10) is facing towards the rear of the machine (Fig.7).
Tighten the hopper locking screw (8).
•
Remove the lid (1) and fill the hopper (2) with coffee beans.
•
•
Reassemble the lid and pull out the hopper closing tab allowing the coffee beans to
move toward the grinding chamber.
42
7. Touch-screen display
8. Hopper locking screw
9. Fork regulation knob
10. Hopper closing tab
11.
Equipotential earthing socket
EN
Publicidad
