Jackson WH20 ASPIRE Manual Del Usuario página 5

WARRANTY
The warranty period of WF20 ASPIRE
these instructions may invalidates the warranty. JACKSON SAFETY
responsibility for any problems, which may arise from applications other than welding.
HELMET AND HEADGEAR ASSEMBLY
1. Insert screws (A) through the openings in the headgear (D).
2. Insert the headgear (D) into the helmet shell (F) as shown in fi gure 1 and push the
screws (A) through the rectangular openings in the helmet shell.
3. Put the tilt adjustment (B) on the right side between the screw (A) and helmet shell (F).
Make sure that a small pin is fi xed in one of the three holes in the helmet shell. Choose
the right hole for your maximum comfort.
4. Tighten the nuts (C) on the screws (A). Before adequately tightening them, place the
headgear at the most comfortable distance from the fi lter opening by adjusting the
possition of headgear within the two rectangular holes in the helmet shell.
5. The headgear size (D) can be adjusted by turning the rear wheel (E) in order to fi t any
head size. Press the wheel and hold it while turning, release the wheel when reaching
the position of maximum comfort, so that it will lock in the required position.
The headgear is equipped with a replaceable sweatband. Sweatbands are avail-
able through your local dealer.
AUTODARKENING WELDING FILTER AND PROTECTION
SCREENS ASSEMBLY /
1. Place the inner protective screen on the inner side of the electro-optical welding filter
as shown on figure (1.).
2. Release the flexible latch (2.a) and lift up the supporting frame (2.b).
3. Insert the filter (mind the orientation!) to the supporting frame on the side closer to
the helmet, so that it clicks in (3.a); then push the free end of the filter to the free end
of the supporting frame that it clicks in again (3.b).
4. Insert the outer protective screen into the filter opening (4.).
5. Lower the supporting frame with welding filter (5.a). Make sure that the two pins on
the top of supporting frame are firmly placed into the two openings on the top of the
filter opening on the helmet body (5.b).
6. Fasten the flexible latch (6.).
AUTODARKENING WELDING FILTER AND PROTECTION
SCREENS ASSEMBLY /
1. Place the inner protective screen on the inner side of the electro-optical welding filter
as shown on figure (1.).
2. Release the flexible latch (2.a) and lift up the supporting frame (2.b).
3. Insert the filter (mind the orientation!) to the supporting frame on the side closer to
the helmet, so that it clicks in (3.a); then push the free end of the filter to the free end
of the supporting frame that it clicks in again (3.b).
4. Insert the outer protective screen into the filter opening (4.).
5. Lower the supporting frame with welding filter (5.a). Make sure that the two pins on
the top of supporting frame are firmly placed into the two openings on the top of the
filter opening on the helmet body (5.b).
6. Fasten the flexible latch (6.).
7. When using the electro-optical welding filter with one or more external potentiometers,
insert the potentiometer housing into the corresponding opening(s) in the inner left
side of the helmet (7.).
8. Tighten the nut on the shade level potentiometer axis and turn the potentiometer to
one of the extreme positions (9 left or 13 right). Set the large shade level potentiometer
knob to the same extreme position just as previously with the potentiometer axis, and
push the knob onto the axis (8.).
PROTECTION SCREEN REPLACEMENT
1. Remove the inner protective screen and replace it with a new one (1.).
4
ADF products is one year. Failure to follow
®
WH20 ASPIRE DS /
®
WH20 ASPIRE ES /
®
does not accept
®
A
Figure
B
Figure
C
Figure
D
Figure