Step 2: Rackmount rails Installation(optional)
1) The rails adjust to mount in 48-cm (19-inch) panel racks from 52 to 91.5cm (20.5
to 36 inches) deep. Select the proper holes in the rack for positioning the UPS in the
rack. The UPS takes up position 1 through position 6.
2) Attach the rackmount rail to your rack with two M5X12L screws and two plastic
washers at the front of the rack. (Located in position 1 & position 6) Do not tighten
the screws. Adjust the rail size on the rail assembly of your rack. Secure the rail to
the rear of the rack with two M5X12L screws and two plastic washers. Tighten all
screws at the front and rear of the rail. Once completed, perform the same steps for
assembling the other rackmount trail.
- 7 -