BETEX HPP Serie Manual De Instrucciones página 11

8.3 Accessories / Tri-section plates
Type Art� no�
Tri-Section 340 791340
8�4 Explanation machine parts HPP Puller
The parts drawing may be requested by sending an e-mail to info@bega.nl. State clearly
which type of puller you have.
9. Troubleshooting
The machine should only be checked or repaired by qualified engineers.
Problem
Too little oil
Press cylinder does not
pressurize
Valve or pump worn
Seals worn
Press cylinder does not
Plunger crooked
retract
Oil comes out at the
front of the press Seals worn
cylinder.
© BETEX Tools
Cap. Min shaft Max shaft
ton diameter diameter
mm mm
20 90 340
Cause
Top up the oil. Clamp the puller horizontally in the vice with the filler
cap facing upwards. Loosen the cap using an Allen key. Ensure that the
press cylinder is completely retracted. Fill the reservoir with hydraulic
oil ISO 46 up to the max.
Send the puller to your supplier for overhaul.
Send the puller to your supplier for overhaul.
If the plunger is crooked, the puller can no longer be repaired. Dispose
of the puller in accordance with the local disposal regulations.
Send the puller to your supplier for overhaul.
Max Thickness Weight
spread mm kg
mm
460 45 16,5
Solution
Use in combination
with
HXP83, 123, 203,
HPP123
11
EN
DE
ES
FR
NL