Inglesina DARWIN 360 i-SIZE Manual De Instrucciones página 19

INSTRUCTIONS
LIST OF COMPONENTS
DARWIN 360° i-SIZE BASE
fig. 1
A Support foot
B Red/green support foot position indicators
C Support foot height adjustment lever
D Isofix connectors
E Isofix connector release levers
F Pushbutton for Isofix connector's disengagement
G Lever to release the Isofix connectors
H Red/green indicators of Isofix connector's engagement
I Red/green indicators for hooking the seat on the base
J Base rotation levers
K Red/green indicators of correct seat direction
L Car seat installation location
M Child seat release lever
N Isofix anchoring points on the car seat
IMPORTANT
• Verify where the Isofix anchoring points are positioned on the seat of the car and
check that they are free from any materials that could prevent their correct use.
• Verify that on the seat of the car there are not any items that may hinder the correct
leaning of the car base to the seat.
• Verify that the floor of the car is free from any materials that may hinder the correct
grip of the support foot.
• Verify that the backrest is in vertical position and the seat where the car base has to
be installed is NOT EQUIPPED WITH ACTIVE FRONT AIRBAG.
• WARNING! Don't install if there is an under-floor storage compartment in the
vehicle.
POSITIONING AND INSTALLING THE DARWIN 360° i-SIZE BASE
fig. 2 Extract the support foot (A) from beneath the car base.
fig. 3 Use the release lever (E) to extract the Isofix connectors (D) completely from
the car base.
fig. 4 Make sure the anchoring indicators of the Isofix connectors (H) are red. If
one or both indicators are green, simultaneously press the button (F) and pull the
release lever (G) to unlock them.
fig. 5 Fasten the base connectors (D) to the seat Isofix anchoring points (N) until
hearing clearly both CLICK sounds signalling the occurred hooking.
fig. 6 Caution: the correct hooking of the Darwin 360° i-Size base occurs
when the proper indicators (H) from red become green
fig. 7 Check that the Darwin 360° i-Size base is properly hooked on both sides.
fig. 8 Press the release levers (E) to unlock the ISOFIX connectors and to approach
the base as much as possible to the car seat backrest.
fig. 9 Then push the Darwin 360° i-Size base firmly from both sides against the
seat until it is fully adhered.
19