Publicidad
Idiomas disponibles
Idiomas disponibles
Item:
OS-PIR-UNV
INSTALLATION INSTRUCTIONS
Parameter Setting By Remote Control:
Note: Factory default settings are as follows: 100% brightness, 100% sensitivity, 10 second hold time, 30 Lux daylight
sensor, 30% stand-by level and 60minute stand-by time.
Mode Setting:
1. Press MODE1 on the remote.
2. Press the up or down arrow to enable editing and to select the parameter to be changed.
3. Once all the parameters have been set to the desired values, press OK to save.
4. Press Mode1 to verify the changes have been saved. Press OK.
5. Standing under a powered-on light, aim the remote at the sensor and press the AUTO button. The light will flash off and
on to confirm.
6. Press MODE1 and once again aim the remote at the sensor. Press SEND. The light will flash off and on to confirm.
Note: Up to 4 modes can be stored in the remote. Follow the steps above 3 more times selecting a different mode each
time.
**NOTE: THESE INSTRUCTIONS DO NOT ADDRESS ALL PERMUTATIONS THAT MAY EXIST IN INSTALLATION, MAINTENANCE, AND OPERATING ENVIRONMENT.
**REMARQUE : CES INSTRUCTIONS NE TRAITENT PAS DE TOUTES LES PERMUTATIONS QUI PEUVENT EXISTER DANS L'INSTALLATION, LA MAINTENANCE ET L'ENVIRONNEMENT D'EXPLOITATION.
**NOTA: ESTAS INSTRUCCIONES NO ABORDAN TODAS LAS PERMUTACIONES QUE PUEDEN EXISTIR EN EL ENTORNO DE INSTALACIÓN, MANTENIMIENTO Y OPERACIÓN.
www.topaz-usa.com | 800.666.2852 | ©2023 Southwire Company, LLC. All rights reserved.
OCCUPANCY SENSOR
Description
Button
Description
Button
Publicidad
