Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 15
m
WARNING!
Never put your hands into the hopper while
the wood chipper + shredder is running. Always use the paddle
supplied with your shredder to push items into the hopper.
3. Only insert as much material as needed to prevent blockage
of the feeding funnel. Chop garden waste that has been
stored for a few days and is wilted and damp alternately with
dry branches. This prevents the cutting blades from blocking
up. Branches with leaves must be completely chopped
before new material is fed. Make sure that the chopped
material can fall freely from the ejection slot.
4. Keep hold of branches while feeding them into the wood
chipper + shredder until they are automatically drawn in.
5. Keep to the working speed of the wood chipper + shredder
and do not overload it.
6. To protect the wood chipper + shredder from clogging, shred
wilted garden waste that has been left to dry for a few days
and shred thin twigs alternately with branches.
7. Before you shred roots, remove any remaining soil and
stones from them.
8. Do not shred soft, damp material such as kitchen waste; take
it straight to be composted.
9. Keep a few dry branches for the end, as they will help clean
the wood chipper + shredder.
10. Only switch the wood chipper + shredder off after all of
the shredding material has passed through the discharge
chutes. Otherwise, the discharge chutes may jam the next
time the shredder is turned on.
Overload Protection
Your electric wood chipper + shredder is designed with overload
protection. If the shredder is clogged during shredding, the
overload protection will cut the power automatically to protect
your shredder. Wait at least 1 minute before restart the unit when
Paddle
the power is cut.
1. To restart the wood chipper + shredder, first press the reset
2. Then, push the removable safety switch to ON position to
Care + Maintenance
m
maintenance, disconnect the unit from the power supply.
m
maintaining.
Cleaning
1. Use only a warm damp cloth and a soft brush to clean your
2. Never spray water on the wood chipper + shredder or wash it
3. Make sure the ventilation slots are always kept clean and are
4. Open the hopper to clean the inside of the unit. Unscrew
11
button (Fig. 16).
Fig. 16
Reset
button
restart the wood chipper + shredder (Fig. 12).
ATTENTION!
Before performing any cleaning or
WARNING!
Always wear gloves when cleaning and
wood chipper + shredder.
with water. Do not use detergents or solvents as these could
cause irreparable damage to your shredder.
free of debris.
the hopper locking knob counterclockwise, and remove the
hopper (Fig. 17).
Publicidad
