sunjoe CJ601E Manual Del Operador página 9

Fig. 5
Wheel cover
6. Repeat the steps 2 – 4 to assemble the other wheel.
Stand Assembly Fitting
1. Turn the wood chipper + shredder main body upside down,
insert the two ends of the stand assembly into the housing
(Fig. 6).
Fig. 6
Stand
assembly
2. Align the holes on the main body housing and stand
assembly, insert the washer into the screw and install into
the stand assembly on both sides (Fig. 7).
Fig. 7
Screw
Washer
Wheel
Main body
Fitting the Paddle Holder and the Paddle
1. Stand the unit up, and clip the paddle holder to the standing
assembly (Fig. 8).
Fig. 8
Standing
assembly
2. Clip the paddle into the paddle holder (Fig. 9).
Fig. 9
Paddle
holder
NOTE: Be sure to place the paddle in the paddle holder every
time after using.
Operation
Starting + Stopping
m
WARNING!
Before starting, ensure that the feed inlet is
empty.
m
WARNING!
The wood chipper + shredder will not run
if the hopper is open or not closed tightly. Always close the
hopper tightly by turning the hopper locking knob clockwise
before starting the machine (Fig. 10).
9
Paddle holder
Paddle