Publicidad
Idiomas disponibles
Idiomas disponibles
GUARD AND FENCE FEATHER BOARD
ASSEMBLY (FIGS. 10 AND 10A)
1. Thread a knurled steel nut (26), knurled side
out, about 2" onto one end of each threaded
rod (24).
2. Slide a 15/32" ID x 59/64" OD x 0.065" washer
(37) onto each threaded rod, then slide the
threaded rods through the guard bracket as
shown in Fig. 10.
3. Slide a washer (37) onto each threaded rod,
then secure in place with knurled nuts (26),
tapered side to the bracket.
4. Thread a knurled nut (26) onto each threaded
rod, tapered side out, leaving about 1/2"
between the nut and the bracket assembly. This
will allow for adjustment of the featherboard.
5. Slide a washer (37) onto each threaded rod,
then slide a feather board onto the rods, noting
orientation as shown in Fig. 10 (the "feathers"
should point in the feed direction). Secure in
place with a washer (37) and 7/16-20 nut (46)
on each rod.
6. Slide a washer (37) onto each threaded rod,
slide the guard onto the rods, curved side out,
then secure guard in place with a washer (37)
and knurled nut (26) on each rod.
7. The completed guard/fence feather board
assembly should be as shown in Fig. 10A.
KNURLED STEEL NUTS
FIG. 10
THREADED ROD
FRONT OF
UPPER
FENCE
Router Table Assembly
ASSEMBLING THE FENCE (CONT.)
15/32" ID X 59/64" OD x 0.065"
WASHER
FEATHER BOARD
(NOTE ORIENTATION)
14
FIG. 10A
7/16-20 NUT
GUARD
Publicidad
