EINHELL CE-CC 18 Li Manual De Instrucciones Original página 22

11. Troubleshooting
Fault
The compressor
does not start up
The compressor
does not switch off
The pressure is set
but the compressor
does not switch off
at the set value
Anl_CE_CC_18_Li_SPK13.indb 22 Anl_CE_CC_18_Li_SPK13.indb 22
GB
Possible cause
- The battery is empty
- The device is not switched on
- The set pressure is too low
- The On/Off /Automatic switch (Fig.
1 / Item 7) is not pressed
- Press the "Manual" switch
- The "Manual" switch (Fig. 6 / Item 7b)
is pressed
- 22 -
Remedy
- Charge the battery
- Press the button Fig. 7 / Item 9b
- Set a higher pressure
- Press the On/Off /Automatic switch
- To switch off , let go of the switchn
- To switch off , let go of the switch
- For automatic mode see section
6.4. point a)
10.07.2023 10:05:42 10.07.2023 10:05:42