Publicidad
Idiomas disponibles
Idiomas disponibles
Programming your remote
Auto Code Search
Auto Code Search is a process where you can
search through all the codes stored in the remote
to find a code for your device. It is recommended
that you read through all the steps below to
familiarize yourself with Auto Code Search before
starting the process.
SETUP
SRP4229B_07 ENG Manual v2.indd 8
SRP4229B_07 ENG Manual v2.indd 8
1.
Manually turn on the device you
wish to control.
NOTE: The Auto Code Search process
cannot be used for devices without
power ON/OFF capability. Use Direct
Code Entry in these cases.
2. Press and hold down the SETUP
button on the remote until the red
light on the remote control turns on.
Release the SETUP button. The red
light will remain on.
NOTE: The red light will either be a
small light at the top of the remote or
the power ON/OFF button.
3. Press and release the device button
on the remote for the type of device
you wish to control, (e.g., TV, DVD,
STR, AUX). The red light will blink
once and remain on.
4. With the remote pointed at the
device, press and release the POWER
button on the remote. The remote
will send 10 different codes to the
device. The red light will blink once
for each code and remain on after
sending the 10 codes.
Did the device turn off?
• If YES, go to Step 5.
• If NO, repeat Step 4 to test the
next 10 codes.
5. Manually turn the device back on.
6. With the remote pointed at the
device, press and release the
VOL
button. The remote will
re-send the first code of the 10 codes
from Step 4. The red light will blink
once and remain on.
8
9/2/21 5:03 PM
9/2/21 5:03 PM
Publicidad
