Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
WARNING:
Do not allow familiarity with this product to make
you careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you
are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
Grinding metals
Sanding wood or metal surfaces
Cutting Metals
INSTALLING/REMOVING BATTERY PACK
See Figure 4, page 11.
Insert the battery pack into the battery port as shown.
Make sure the latch on the battery pack snaps into place
and the battery pack is secured in the product before
beginning operation.
D epress the latch and pull to release and remove the
battery pack.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
WARNING:
Battery tools are always in operating condition. Lock
the switch when not in use or carrying at your side,
when installing or removing the battery pack, and when
installing or grinding wheels or accessories.
STARTING/STOPPING CUT-OFF TOOL/
GRINDER
See Figure 5, page 12.
To turn the tool ON:
Install the battery pack.
Hold the tool in front and away from you, keeping the
wheel clear of the workpiece.
To start the tool, grasp the handle and side handle firmly.
Push the lock-out switch forward and squeeze the paddle
switch.
To turn the tool OFF:
To stop the tool, release the paddle switch. Make sure
the tool comes to a complete stop before laying down
the tool.
POSITIONING THE WHEEL GUARD
See Figures 6 - 7, pages 12.
NOTE: The procedure for positioning the wheel guard is the
same with or without the guard insert attached.
The wheel guard on the tool should be correctly positioned
depending on which location the side handle is mounted
and depending on what type of operation you are per-
forming (cutting or grinding). Never use the tool without a
wheel guard correctly in place or when the index arrows
are aligned.
WARNING:
Never place the guard so that it is in front of the grinder.
This could result in serious injury because sparks and
loose particles thrown from the grinding wheel would be
directed toward the operator. Always place the guard in
the correct location as shown.
To adjust the wheel guard:
Remove the battery pack.
Depress lever and rotate the guard to its correct position
as shown.
NOTE: Be sure the raised ridge on the guard is seated in
the groove on the bearing cap. Never use the tool without
a guard in place and properly adjusted.
9 – English
Publicidad
