Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
WARNING!
Keep all parts of the body away from the
saw chain. Make sure the switch is off
when clearing jammed material. The saw
chain continues to move after the switch
is turned off. A moment of inattention
while operating the extended-reach pruner
may result in serious personal injury.
WARNING!
Carry the extended-reach pruner by the
handle with the saw chain stopped. When
transporting or storing the extended-reach
pruner, always fit the saw chain device
cover. Proper handling of the extended-
reach pruner will reduce possible personal
injury from the saw chain.
Do not overwork yourself. Take regular breaks
and change working position to ensure you
can concentrate on the work and have full
control over the product. Maintain firm footing
and balance during operation.
ADJUSTING THE TELESCOPING
HANDLE
1. Unlock the telescope release lever so that
the pole can freely extend outwards and
inwards.
2. Extend it to the desired length and lock the
telescope release lever to hold it in place.
ADJUSTING THE HARNESS
Adjust the harness to a length which is
suitable for your operation (Figure 6).
Always use the harness to carry the product
weight on your shoulder (on the same side of
tool or cross your body)!
Ensure that the quick release is on your chest
(NOT on your back).
Open the quick release clamp (Figure 7) if it
is necessary to open the harness quickly.
Short
Figure 6 - Adjust harness length
WWW.SENIXTOOLS.COM
Long
Figure 7 - Quick release of harness
TURNING THE POLE SAW ON
AND OFF
To turn ON, hold the pole saw firmly with
both hands. Press and hold the safety switch
located on the left-hand side of the rear
handle above the main power trigger.
Press down the trigger to turn it ON. The
safety switch can now be released.
To turn OFF, release the ON/OFF trigger
switch.
PREPARATION
Before each use, check the following items to
ensure safe working conditions.
POLE SAW: Before beginning work, inspect
the pole saw for damage to the housing,
the extension cable, the saw chain and the
guide bar. Never use an obviously damaged
machine.
OIL TANK: check the fill level of the oil
tank. Also check whether there is sufficient
oil available while working. Never operate
the saw if there is no oil or the oil level has
dropped below the minimum oil level mark
in order to prevent damage to the pole saw.
On average, an oil filling is sufficient for
approximately 10 minutes of cutting operation
(depending on the duration of pauses and the
density of the workpiece).
SAW CHAIN: check the tension of the saw
and the condition of the blades. The sharper
the saw chain is, the easier and more
manageable operations will be. The
same applies to chain tension. Check the
tension every 10 minutes of operation to
maximize safety. New saw chains in particular
are subject to changes due to the heat
created by operation.
OPERATION
11
Publicidad
