Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION/MAINTENANCE
PROTECTIVE CLOTHING: make sure to
wear the appropriate close-fitting protective
clothing such as chainsaw-protective pants,
gloves and safety shoes. Wear a safety
helmet with integrated hearing protection and
a face guard to provide protection against
falling and recoiling branches.
HEAD ADJUSTMENT: The angle of the
saw's head can be adjusted anywhere from
0 to 30 degrees by pushing down on the
Angle Adjustment Button. If you would like
to change the angle of the saw's head, first
remove the battery and then adjust to the
desired angle.
MAINTENANCE
WARNING!
Remove the battery before inspecting,
adjusting, performing maintenance, or
cleaning the unit.
CLEANING
• Brush or blow dust and debris out of the air
vents using compressed air or a vacuum.
Keep the air vents free of obstructions,
sawdust, and wood chips. Do not spray,
wash, or immerse the air vents in water.
• Wipe off the housing and the plastic
components using a moist, soft cloth. Do
not use strong solvents or detergents on
the plastic housing or plastic components.
Certain household cleaners may cause
damage or cause a shock hazard.
• Routinely clean out the dust and debris
that gathers under the tension housing,
the oil outlet, and around the bar and the
chain sprocket. Otherwise it can jam up
the sprocket, the chain, and the lubrication
system.
REPLACING THE SAW CHAIN
AND GUIDE BAR
WARNING!
Only use replacement bar/chain
combination listed. DO NOT use any other
bar/chain combination.
CHAIN AND BAR COMBINATIONS
Combination
10 inch (254 mm)
12
Guide Bar
Saw Chain
AP10-40-507P
3/8.05040S
The guide bar must be replaced if the groove
of the guide is worn out or the spur wheel in
the guide bar is damaged or worn out.
1. Loosen the cover release knob to release
the chain sprocket cover (Figure 1).
Remove the chain sprocket cover.
CAUTION!
Always wear protective gloves when
handling saw chains.
2. Lift the worn saw chain out of the fitted slot
in the guide bar.
3. Place the new chain in this position,
making sure the teeth are facing the correct
direction and that the edge of the chain fits
into the slot around the guide bar (Figure 2).
4. Replace the cover and tighten the release
knob. Adjust tension before operating.
WWW.SENIXTOOLS.COM
Publicidad
