Jofel AA17050 Manual De Uso página 21

Install the terminal block cover
(1) Put the terminal block cover on the
terminal block and fix it with install
5
screws.
(2) Ensure the power lines get through
the cabling channel and the terminal
block cover is flat after installed.
Fix the unit
(1) Tidy the power lines and press the extra parts
into the terminal block on wall.
(2) Hang the pothook on the back of the unit
6
into the hanging trough of the install panel
and ensure the unit hung stably and close to
wall.
(3) lnstall the anti-thief screws for the unit (2pcs)
Note: The unit must be installed with the anti-
thief screws, or else it may cause the unit
off and be stolen.
1. Install the airfilter
• Push the air filter up into the unit totally,
then close the air inlet door and lock it
with the knob lock.
7
2. Install the drain tank
• Push the drain tank into the unit as the
diagram showing.
Test Run
Step
1 Check the voltage of power supply
2 Turn the ground-fault circuit breaker on
3 Turn the power switch on
4 Dry hands
5 Check the unit
* Do not turn the unit power switch on with your hands inside.
Installation panel
Safety screw
Check
Please use the rated voltage?
Dose the lamp light up?
Is the air blowing?
Is the unit installed firmly? Any vibration or
strange noise?
- 21 -
Installation Procedures
terminal box
Pressure
line cover
Power cords
electric cover
unit
hook
unit
drain tank
Result
air filter