Publicidad
Idiomas disponibles
Idiomas disponibles
Before you begin:
Open, identify and count all parts prior to assembly. Lay out parts on a flat and non-abrasive
surface. You will need the parts identified on page 4 and 5 of this instruction manual.
NOTE:
IT IS VERY IMPORTANT TO USE GLUE WITH DOWELS. EXCESS GLUE CAN BE WIPED OFF
WITH DAMP CLOTH.
Insert the Dowel at least halfway by tapping lightly with a rubber mallet, IF NECESSARY.
HOW THE KNOCK DOWN (KD) ASSEMBLY SYSTEM WORKS
1. Screw the Cam Bolt into the threaded inserts on the panel. Connect both panels together; making sure Cam
Bolt goes into the pre-drilled hole on the end of panel for Cam Lock.
2. Insert the Cam Lock into the pre-drilled large hole on the panel. Make sure the arrow on the face of Cam
Lock faces out and points towards Cam Bolt.
3. Take a Phillips screwdriver and rotate the Cam Lock clockwise to lock the Cam Bolt in place.
CAM LOCK SYSTEM OPERATION
1
You are now ready to assemble the KD unit.
IMPORTANT
2
3
3
Publicidad
