Publicidad
Idiomas disponibles
Idiomas disponibles
7. Cleaning and Maintenance:
Please follow these directions along with Important Safety steps for cleaning，advised at the
beginning of the manual. Use a ceramic glass cleaner on the glass cooktop. To maintain and
protect the surface of your induction cooktop，follow these steps:
Before using the cooktop for the first time，clean it to protect the top and makes cleanup easier.
1. Daily use of ceramic glass cleaner when the cooktop is cool will keep the cooktop looking new.
2. Shake the cleaning solution well. Apply a few drops of ceramic glass cleaner directly to the cooktop.
3. Use a paper towel or a soft cleaning pad for ceramic surface to clean the entire cooktop surface.
4. Use a dry cloth or paper towel to remove all cleaning residue. No need to rinse. Never run the
cooktop under water.
Cleaning Burned on Residue:
NOTE: It is very important that you DO NOT use the cooktop until it has been thoroughly cleaned.
WARNING: Damage to the glass surface may occur if you use scrub pads or any other type of
abrasive cleaning materiaIs.
1. Allow the cooktop to cool.
2. Spread a few drops of the ceramic glass cleaner on the burned residue area.
3. Using the ceramic glass cleaning pad，rub the residue area，applying pressure as needed.
4. If any residue remains，repeat the steps listed above.
5. For additional protection，after all residue has been removed，polish the entire surface with the
ceramic glass cleaner and a paper towel.
Cleaning heavy burned - on residue:
1. Allow the cooktop to cool .
2. Used a single-edge razor blade scraper approximately at a 45 degree angle against the glass
surface and scrape off the residue.
3. After scraping off the residue，apply a few drops of the ceramic glass cleaner on the entire
burned residue area. Use the cleaning pad to remove any remaining residue.
4. For additional protection，after all residue has been removed，polish the entire surface with
the ceramic glass cleaner and a paper towel.
Metal Marks and Scratches:
Be careful not to slide pots or pans across the cooktop surface. lt will leave behind metal markings.
These marks are removable using the ceramic glass cleaner along with the cleaning pad for
induction cooktop.
If pots with a thin overlay of aluminum or copper boil dry，the overlay may leave a black
discolorationon the cooktop. This should be removed immediately before using the cooktop again
or the discoloration will become permanent.
NOTE: If cracks or indentations in the glass surface occurs，the cooktop glass will have to be
replaced. Contact the manufacturer for assistance.
12
Publicidad
