Veratron VIEWLINE A2C59512370 Manual Del Usuario página 9

INSTALLATION INSTRUCTIONS: Viewline 85 mm
Speedometer
1. Activate Term. 30 (8-pin - Pin 1)
3. Press and hold down the config. button (14 pole - Pin 11)
short press
short press
short press
Safety information:
• The AutoCal function is used in moving vehi-
cles. For reasons of traffic safety, this function
is only allowed to be used when two people are
in the vehicle. Only the passenger is allowed to
operate the monitor during the test and calibra-
tion drive
long press
short press
long press
long press
long press
short press
long press
long press
short press
short press
long press
Technische Änderungen vorbehalten - Technical details subject to change
TU00-0752-7407102
2. Deactivate Term. 15 (8-pin - Pin 4)
1a. Function Pulse
Set impulse number is displayed,
the first digit flashes.
The flashing digit increases by 1.
If the flashing digit is "9", the display
returns to "0"
The next lower digit flashes.
1c. Signal source
Press the Config. key to changeover
between the frequency input (8-pole plug,
Pin 5) and the NMEA0183 input (14-pole
plug, Pins 1 and 2).
short press
1b. Function AutoCal
Drive to the measuring section and press
the button for a long time. Please note: the
display exits the „button" menu within 30
sec. if the measurement is not started.
Press the button briefly, when you reach
the starting point of the measuring section.
The LCD displays the accumulated impuls-
es.
Press the button briefly, when you reach
the end of the measuring section.
The LCD displays the ascertained
short press
pulse count.
10/15
1-11 7
GB