Uline H-10657 Manual De Instrucciones página 3

WARNING! If the mounting distance is too close
to the basin or other obstacles, the LED will
blink green and red to remind user to remove
obstacles ahead of the sensor or to mount the
dispenser higher.
FILLING CARTRIDGE
1. Open dispenser.
2. Unscrew cartridge lid to open.
3. Fill with liquid soap or gel hand sanitizer and
replace lid.
4. Turn on dispenser by pressing ON/OFF button.
(See Figure 8)
ADJUSTING DOSAGE
Press dosage button to
choose dosage. There are
three options. (See Figure 8)
Indicates one pump
each time the dispenser
releases soap.
Indicates two pumps
each time the dispenser
releases soap.
Indicates three pumps
each time the dispenser
releases soap.
PAGE 3 OF 9
INSTALLATION CONTINUED
Figure 8
ON/OFF
Button
Dosage
Lights
Dosage
Button
1-800-295-5510
uline.com
SETTING THE DISPENSING VOLUME
1. Press the button to turn the dispenser on/off.
2. Press to choose the volume of soap to dispense:
= Press once for the standard amount.
= Press again/twice for double the amount.
= Press a third time for triple the amount.
NOTE: If the red LED blinks frequently, the
voltage is low. Press
batteries and the LED will become normal.
to turn off. Replace the
0724 IH-10657