Publicidad
Idiomas disponibles
Idiomas disponibles
3. INSTRUCTIONS FOR USE
3.1 Before first use
1.
Lay the product evenly on the mattress, making sure it lies flat and without creases.
2. The product should be positioned so that the plug and cables are at the top of the mattress,
where the pillow will lie. Make sure the control panel is easily accessible.
3. Tighten elastic bands around the corners of the mattress.
4. Place the fitted sheet or mattress topper on top of the product. Make sure the control panel
and cable remain clear.
3.2 How to use
1.
Insert the control panel plug into the control panel power connector.
2. Insert the power plug into the power outlet.
3. Slide the control panel switch upward so that ON appears and the display turns on.
4. Press the control panel buttons to set the heater setting and timer to the desired modes.
5. Slide the switch down so that OFF appears, the display turns off and the product turns off.
6. Unplug the product and wait for it to cool before storing it.
Note
◊
To save energy, the display turns off after 10 seconds when the control panel is not in use.
The product will then continue to heat at the selected settings.
◊
When switched on, the heater defaults to setting 9 and the timer to setting 1.
3.3 Setting the temperature
The product is equipped with two separate heating elements that each heat a part of the
product: the upper body at the top of the product and the lower body at the bottom. The two
heating elements can be operated separately from each other.
1.
Press "Body" repeatedly to set upper body heating mode. Press "Feet" repeatedly to set the
heating mode for the lower body. The heating setting is shown on the display.
2. If necessary, adjust the heating setting if you find it too hot or too cold.
3. To turn off a heating element, press the element button repeatedly until "0" appears on the
display.
Note
◊
You can set the heating setting from position 1 (low) to position 9 (high). When you turn the
product on, the heating setting is set to position 9 by default.
◊
We recommend that you select a heating setting between 6 and 9 10 to 15 minutes before
bedtime to preheat the product and select a lower setting between 1 and 3 at bedtime.
Before falling asleep, it is recommended to set the timer so that the product automatically
turns off.
24
Publicidad
