babymoov Slick A010403 Instrucciones De Uso página 6

EN.
READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
• Never leave the child unattended.
High chair function
• Always use the restraint system.
• Falling hazard: Prevent your child from climbing on the product.
• Do not use the product unless all components are correctly fitted and adjusted.
• Be aware of the risk of open fire and other sources of strong heat in the vicinity of the product.
• Be aware of the risk of tilting when your child can push its feet against a table or any other structure.
• Use the high chair only if the child is able to sit alone
• Check the high chair often to ensure screws are tight, for wear, torn fabric or unstitched points. If there is any damage to the
chair, do not use it and keep it out of the reach of children. If there is any damage to the chair, do not use it and keep it out of the
reach of children.
• WARNING! Use this harness all the times. A five-point harness is provided to restrain your child. Any harness used other than the
one provided by Babymoov must comply with EN 13210.
• To avoid any injury, keep children away from the product when folded or unfolded.
• This product is designed for children capable of sitting up unaided, up to a maximum age of 3 or weighing up to 15 kg.
Reclined cradle function
• Do not use the reclined cradle once your child can sit unaided.
• This reclined cradle is not intended for prolonged periods of sleeping.
• It is dangerous to use this reclined cradle on an elevated surface, e.g. a table.
• Always use the restraint system.
• This reclined cradle does not replace a cot or a bed.
• Should your child need to sleep, then it should be placed in a suitable cot or bed.
• Do not use the reclined cradle if any components are broken or missing.
• Do not use accessories or replacement parts other than those approved by the manufacturer.
When used as reclined cradle (adjusted to the most flat position), it suits to EN 12790. Other positions suits for
EN 14988:2017+A1:2020.
A. Seat
B. High chair leg frame
C. 2 front legs
D. 2 back legs
E. Tray
F. Seat height adjustment system
G. Reducer
1. Remove parts A, B, C, D and E from the box.
2. Attach the 4 legs (C & D) to the frame (B).
Ensure the legs (C & D) are inserted into the frame (B) using the stickers on each leg. The letters must be identical on each part
(A with A, B with B, etc.). The feet with the wheels should be at the back of the product.
To ensure the product is stable, make sure the flat part is fully in contact with the floor.
3. Position the seat (A) into the tubes of the frame (B), by simultaneously pressing the 2 height adjustment buttons (F) on the seat
(A). Ensure that the Velcro
4. To finish assembling, insert the tray (E) into the slots on each side of the seat (A) by pressing the buttons (J) on each side of the
seat (A).
6
IMPORTANT!
COMPONENTS
CHAIR ASSEMBLY
®
strip located underneath the cover is attached to the metal frame.
SLICK ∙ SLICK
WARNING
H. Footrest
I. Footrest height adjustment system
J. Button for opening/removing the tray
K. Harness
L. System for tilting the seat
M. Removable crotch post
N. Foam
• Instructions for use
Navy