Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
PROBLEM
Warning indicator
is flashing
Warning indicator
is illuminated
continuously
Espresso
and warning indictors
are flashing at the same time
No coffee bean
and warning
indicators
are flashing at the
same time.
The brewer cannot be removed.
The device foams milk poorly/does not
foam the milk.
TECHNICAL DATA
Technical specifications are given on the product nameplate.
Length of mains cable: 1.05 m
CAUTION! MPM agd S.A. reserves the right to technical changes!
Proper disposal of the product (waste electrical and electronic equipment)
Marking on the product indicates that after the service-life of the product expires, it should not be dis-
posed with other type of municipal waste. Used equipment may have a negative impact on the environ-
ment and health of people due to potentially containing hazardous substances, mixtures and components.
Mixing electric waste with other types of waste or disassembling those in an unprofessional manner may
cause a release of substances that are hazardous to the environment and health. Used equipment should
be handed-over to a point for collection of electric waste. In order to obtain detailed information regarding the
electric waste collection points, the user should contact the municipal point of electric waste collection or used
equipment processing department.
CAUSE
The grinding level adjustment knob and
internal drip tray are not fitted correctly.
The brewer or the internal drip tray are
not fitted correctly.
The grinder is not working correctly
The device completed 16 cycles of
continuous coffee bean grinding without
a 5-minute break between the cycles, all
the functions of the device will become
inactive.
The device was not switched off correctly
- the brewer is locked.
The milk is not sufficiently cold or is not fit
for foaming.
The milk frother is clogged/dirty.
METHOD OF REMOVAL
Fit the grinding coarseness adjustment
knob and internal drip tray.
If you cannot remove the problem, contact
the service centre.
Fit the brewer or internal drip tray properly.
If you cannot remove the problem, contact
the service centre.
Switch off the device and start it again.
If you cannot remove the problem, contact
the service centre.
Leave the device for 5 min. to cool off.
Switch off the device and start it again.
If you cannot remove the problem, contact
the service centre.
Switch off the device and then switch it one
again to reset the brewer.
If you cannot remove the problem, contact
the service centre.
It is recommended that the temperature of
the milk is 5-10°C and that the fat content of
the milk is at least 3%.
Clean the milk frother and the milk foaming
system.
EN
55
Publicidad
