Publicidad
Idiomas disponibles
Idiomas disponibles
C3
2. Insert the replacement line through the eyelet
(Line In) and feed it out through the other eyelet.
Ensure both ends of the line are even on each
side of the trimmer head (recommended
6.5 ft (2 m) and cut the line. (See Fig. C2)
3. Turn the dial clockwise to wind the line around
the spool until about 6''(16 cm) remains on either
side. (See Fig. C3)
Lubricating the gearbox (See Fig. D1, D2)
1. Remove the screw on the gearbox.
EN
2. If there is no bevel gear grease on the end of the
screw, squeeze 5 g of the gear grease (SHELL
Gadus S2 V220 1) into the gear housing.
3. Refit and tighten the screw firmly.
4. Install the battery and run the trimmer for 1
minute to ensure the gear is evenly lubricated.
D1
10
D2
Assembling and disassembling the Power
head attachment. (See Fig. E1, E2, E3)
1. Remove the protective cap from the end of the
attachment shaft.
2. To assemble, align the triangle icon on the button
with the arrow label on the attachment shaft.
3. Push the shafts together until you hear a "click".
The edge of the arrow label should be close to
the shaft connection housing.(Note: If the trimmer
shaft cannot be fully installed into the power hear,
rotate the trimmer head a little until it is possible
to insert the shaft fully.)
4. Finish the assembly by tightening the knob
clockwise.
5. To disassemble, loosen the knob, turn counter
clockwise, then press the release button and
pull the shafts apart. Replace the protective cap
on the attachment shaft to ensure that dust and
debris do not get into the shaft.
E1
Publicidad
