Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
The following table gives problems and actions that you can perform if your machine does not operate
correctly.
WARNING: Switch the machine off and remove the battery prior to any troubleshooting.
TRIMMER
Problems
Battery indicator LED
flashing
Red error LED flashing
The product does not start
Trimmer runs intermittently
EN
Excessive vibrations/ noise.
TECHNICAL DATA
Type Designation: KAC105
Cutting speed
Cutting diameter
Line diameter
Degree of protection
Machine weight
(Bare tool)
12
Possible Causes
Low battery voltage.
Overload.
Temperature issue.
The Throttle Trigger and the
start/stop button are pressed
at the same time.
Other problems
Deris in the battery
connectors.
Other problems
The battery is not fully
inserted to the machine.
Potential electrical issue.
Line balance issue.
Cutting attachment issue.
Machine defective.
Corrective Action
Charge the battery.
The cutting attachment is jammed.
Deactivate the product. Remove the
battery. Clean the cutting attachment from
unwanted materials.
Let the product cool down.
Release Throttle Trigger. Perform the
starting sequence again.
Contact Service Agent
Clean the battery connectors with
compressed air or a soft brush.
Contact Service Agent.
Insert the battery fully.
Contact Service Agent.
Rewind the line.
Replace cutting attachment.
Contact Service Agent.
KAC105
4500 / 5900 rpm
16.5'' (42cm)
.095'' / .105'' (2.4 / 2.7 mm) nylon line
IPX4
3.3 lbs (1.5 kg)
Publicidad
