Publicidad
Idiomas disponibles
Idiomas disponibles
FlashLight
Connecting Instruction
Note: Connect J1 or J2, can't connect both 2. J3 should be connected with shielding line
1) Connect the wire with J1 if power supply is 85-265VAC.
2) Connect the wire with J2 if power supply is 12-24VAC/DC.
3) J3 is for connecting the antenna to extend the e ective distance of controller
Instructions
1) LED will icker in 1HZ after power on.
2) 2 JP2 switch It's the switch for switching LED in ickering or lighting,
When JP2 at FLASH, LED will icker in 1Hz after power on; When JP2 at NO FLASH, LED will light after power on.
Installation
1) Open the package and take out
the accessories for installation.
3) Remove the paper and insert the nails to
ensure.
85265
Figure 4
Figure 6
1) Stick the paper on the proper place, and then drill
the hole and t the expansion sleeve.
4) Press the holes in the base into the lamp.
Opening your life
Figure 5
Figure 7
2
Publicidad
