Publicidad
Idiomas disponibles
Idiomas disponibles
the reel to the monitor (see below picture - right).
3.
Put the fuse into the jack located at the side of the battery box.
4.
Plug the power adapter cord into the AC socket and the other end into the DC
12V-Input jack on the monitor. If you choose to use the charged battery, plug
the power output cord of the battery to the DC 12V-Input jack of the monitor,
then press the button on the battery.
NOTE: The user can also charge the battery while using the device in the
5.
following way: plug the charger to the wall AC socket and the other end
to the jack on the battery, and connect the power output cord of the
battery to the DC 12V-input jack of the monitor, then press the battery's
button. Don't mix up the power cord and battery charger cable,
otherwise the system can not work properly, or the battery pack may
be damaged.
6.
Press the POWER button on the front of the monitor.
7.
Gently lower the camera into a pipe duct, etc and reel out the cable until it is at
the desired depth.
8.
Press the LED button and adjust the brightness from the MENU.
9.
Record the pictures if you need for the models featured with DVR.
10. When you finish the job, carefully remove the camera from the pipe duct, etc.
Screw out the camera head and clean it with a clean, soft and dry cloth and
then put the camera into the previous position.
System Menu Setting
Clock setting: set date and time
Time Format
Year
Select: 24-Hr / 12-Hr
Set year
Publicidad
