GE PVM1790 Instrucciones De Instalación página 10

Installation Instructions
[0D] ALIGNING THE WALL PLATE
|
|
7 | o
lo t
7 . Hole B
Hole A Draw a Vertical
Line on Wall
i~&— from Center of
Top Cabinet
i
io oe
ai | __|
o ° i
| Vo 9570707070 20707 0907079907070 2 0707090 TE—_AP DI
Hole C -KSSESS=SSSS=SSS==TT== PISS S SSS SSSI SITS SS Sas Hole D
|
Area E
Wear gloves to avoid cutting
fingers on sharp edges.
Draw a vertical line on the wall at the center of the 30" NOTE: Holes C and D are inside area E. If neither C nor D
wide space. is in a stud, find a stud somewhere in area E and draw a
Use the mounting plate as the template for the rear wall. fifth circle to line up with the stud. It is important to use
Place the mounting plate on the wall, making sure that at least one wood screw mounted firmly in a stud
the tabs are touching the bottom of the cabinet or to support the weight of the oven.
the level line drawn in Step C for cabinets with front Set the mounting plate aside.
overhang. Line up the notch and center line on
the mounting plate to the center line on the wall. A WARNING risk of electric shock. Can
While holding the mounting plate with one hand, draw cause injury or death. Take care to not drill into electrical
circles on the wall at holes A, B, C and D (see illustration wiring inside walls or cabinets.
above/actual plate marked with arrows). Four holes
. . . h e ay"
must be used for mounting. Drill holes on the circles. If there is a stud, drill a 716" hole
for wood screws. For holes that don't line up with a stud,
drill a ¥s" hole for toggle bolts.
NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.
10