Seko WareOne PR Manual De Instalación página 3

WareOne PR / PRS
Variable capacity peristaltic pump regulated through speed control
NOTICE
When installing the pump read the label and verify the
following:
• tubing material is compatible with the liquid;
• the power supply available is identical to the
indicated one;
• pressure at the injection point is lower or equal to
the pump nominal pressure;
• suction tubing is inserted in the liquid container,
fitted to the suction connection of the pump
(represented on the lid with ) and tightened with
the proper nut
• delivery tubing is fitted to the delivery connection of
the pump (represented on the lid with ), tightened
with the proper nut and fitted to the tank injection
connection;
• the protection lid of the liquid end is properly fitted
in its seat;
• the pump is connected to an electric system which
has an all-poles disconnection device with open
state distance between contacts of at least 3 mm
(0.12").
B
EFORE CARRYING OUT ANY OPERATION ON THE PUMP
IF ANY OF THE INSTRUCTIONS HERE CONTAINED IS NOT RESPECTED THERE CAN BE DAMAGE TO
PERSONS AND/OR INCORRECT WORKING OR DAMAGE TO THE APPARATUS
INSTALLATION INSTRUCTIONS
Installation with the provided bracket
• Fix the metal bracket with the provided screw.
• In case of tiled or low friction walls use the supplied adhesive tape as follow:
o
peel off one of the two protective foils from the tape, stick the tape to the bracket;
o
peel off the second protective foil and proceed to fix the bracket with the provided screw;
• fix the pump on the bracket making tongues on the back of the pump slide in the bracket.
Installation with the back cover
• Open the pump unscrewing the fixing screws on the box;
• Detach the power supply connection from the circuit;
• holes for mounting are on the back cover of the pump: break the plastic protections from the holes with an awl
or screwdriver (to trace the drilling template the back cover can be used);
• fix the back cover with the provided screw or with Ø 4 mm (0.16") screws;
• reattach the power supply connection to the circuit and mount the front part of the pump with the fixing screws.
0000138257

IMPORTANT
rev. 1.0 EN
Dimensions
(W x H x D)
Max suction height

,
DISCONNECT THE POWER SUPPLY
INSTRUCTIONS MANUAL
98 x 134 x 118 mm
(3.85" x 5.3" x 4.6")
1.5 m (59")
!!
1