Descargar Imprimir esta página

Seko WareOne PR Manual De Instalación página 4

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 7
WareOne PR / PRS
Suction filter installation
• Insert the end of the tubing in the weight so that it exits from the flared part; insert the filter container in the
same end of the tubing;
• tighten the tubing screwing the weight until it sits on the filter container;
• It is strongly recommended to use the suction filter in all situations, to assure that it reach the bottom of the
tank and to clean it periodically to avoid dry residual of product or accumulation of dirt.
Capacity regulation
• To modify the capacity, take out the protection tap on the right of the operation led with a screw driver 5 x 20;
• to reduce capacity, turn the trimmer counter-clockwise.
Tubing substitution
• Disconnect the pump from the power supply
• take off the transparent lid on the hydraulic group.
To dismantle the tube,
• turn the roll holder so that the rollers are on a vertical line
• remove from its seat the connection on the left of the pump,
• alternatively pull the tube out of its seat and manually rotate the roll holder clockwise until it is possible to
extract the right-hand side connection from its seat;
To mount the tube,
• turn the roll holder so that the rollers are on a horizontal line;
• insert the connection in its seat on the left of the pump with the curved side towards the floor;
• alternatively push the tube into its seat and manually rotate the roll holder clockwise until it is possible to insert
the right-hand side connection into its seat;
• insert the protection lid starting from the top, with the shear facing the pump and pushing slightly on the sides
so to hear the click.
0000138257
rev. 1.0
EN
INSTRUCTIONS MANUAL
2

Publicidad

loading

Productos relacionados para Seko WareOne PR

Este manual también es adecuado para:

Wareone prs