Publicidad
Idiomas disponibles
Idiomas disponibles
3 | Installation
3
Installation
Locate a suitable position in the driver's cabin to install the con-
trol unit, taking into account:
1.
the detailed dimensions of the NEO 2 Control unit (see
chapter 4, "Dimensions" on page 5).
2.
the front panel dimensions:
Fig. 2 Front panel dimensions
3.
the built-in depth. Provide additional headroom for wiring:
*For reference only
Fig. 3 Built-in depth
Damage to wiring and components due to incor-
rect mounting location
Make sure the space behind the control unit is appro-
priate before creating a cut-out.
4.
the cut-out size:
Minimum thickness = 1.6 mm [0.063 in]
Maximum thickness = 3.8 mm [0.150 in]
Fig. 4 Panel cut-out
– Create a cut-out with dimensions 113.3 mm wide and
53.1 mm high.
4 / 33
Connection Detail*
Panel cut-out
5.
Connect the NEO 2 Control unit to the equipment to be
controlled. The NEO 2 Control unit contains two connect-
ors, CN1 and CN2. Following figure indicates the position
of these connectors:
CN2
Fig. 5 Connector positions
6.
Establish the connection to CN1 according to:
- chapter 5, "Wiring diagram" on page 5.
- chapter 6, "CN1 Connector" on page 6.
7.
Establish the connection to CN2 according to:
- chapter 5, "Wiring diagram" on page 5.
- chapter 7, "CN2 Connector" on page 6.
8.
Mount the NEO 2 Control unit:
Fig. 6 Mounting the Neo 2 Control unit
CN1
6248362A_OI_NEO 2 Control unit
Publicidad
