Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Description
1.
Measuring cap
2.
Lid including gasket
3.
Jug
4. PrecisionCrush blade
5. Texture modes
6. START/STOP button
Speed Control/Program dial
7.
Motor base
8. Tamper
9.
Power cord
10. Cord storage (on back side)
Before First Use
Clean all parts before using the blender for
the first time – refer to "Care and Cleaning".
(A) Using the Jug
Be careful when blending hot liquids in the
jug using the manual mode. Start blending
on speed 1 to avoid possible burns due to
escaping steam and splashes. The maxi-
mum allowed amount of hot liquid ingre-
dients in the jug is 40 fl.oz. / 1250 ml.
Manual Mode
Select a speed (1-10) (6) and press START/
z
STOP to start blending.
START/STOP
turns
z
during operation.
To finish press START/STOP again and
z
turn the dial back to "0".
For detailed processing instructions refer
to table I.
permanently
on
Automatic Food Programs &
Texture Modes
First, select one of the 3 automatic food
z
programs (6).
The texture mode (5) pre-set to the
z
selected program turns permanently on.
Optionally you can select another texture
mode.
Press START/STOP to start the program.
z
The program stops automatically.
z
To stop the program in advance, press
z
START/STOP again.
For detailed processing instructions refer
to table I.
Pulse Mode
The pulse mode can be used to break apart
larger pieces of food or to control the text-
ure of food when chopping. Duration de-
pends on how long you press the START/
STOP button (6).
Using the Double Function
Measuring Cap
During operation use the measuring cap (1)
to slowly add oil through the dripping hole
to emulsify sauces and dressings (Fig. a) or
easily add small amounts of liquids (Fig. b).
By removing the measuring cap, you can
add additional ingredients or liquids at low
speed (Fig. c).
Using the Tamper
It helps to push unmixed ingredients down
from the jug wall and to bring thick mix-
tures into the blades while blending. The
supplied tamper (8) will not touch the bla-
de when used through the opening of the
measuring cap (1).
Note: It must be used only when the main
part of the lid is in place.
13
Publicidad
