DeWalt DCV580 Manual De Instrucciones página 13

3. Clean the filter by shaking off excess dust, tapping into a waste
receptacle, then rinsing under running water. Depending on the
condition of the filter, a water wash is not always required. Do not
use a brush to clean filter.
4. Reinstall and secure the filter onto the power head by twisting the
filter to the left.
5. Replace power head onto the tank and secure latches.
Blower (Fig. 2)
The blower function can be used to remove debris from behind small
spaces, to dry a damp floor, to blow grass clippings or leaves from
an outside walk, patio, etc.
TO USE AS A BLOWER
1. Empty the tank following the instructions under the Vacuum
Cleaning section of this manual.
2. Twist the vacuum hose (B) to remove.
3. Insert the hose into the side exhaust port (F) and twist to secure.
MAINTENANCE
WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
• Empty the vacuum often, especially when wet debris is in the
canister.
• MAINTAIN TOOL WITH CARE. Keep fan area clean for best and
safest performance.
• Do not attempt to repair the vacuum. To assure product safety
and reliability, repairs, maintenance, and adjustments should be
performed by authorized D WALT service centers.
E
Hose and Accessory Storage (Fig. 2)
When the vacuum is not in use, the hose can be wrapped around
the appliance, underneath the battery interface, and secured with
the hose clip (G) also located at the back of the vacuum. The two
accessories (crevice tool and wide nozzle) can be stored on board
the vacuum as well.
Lubrication
Never lubricate the vacuum motor. The motor bearings are permanently
sealed. This vacuum is intended for indoor use and for wet or dry pick
up, but it is not intended to be exposed to rain.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do not
use water or any cleaning solutions.
11