Publicidad
Idiomas disponibles
Idiomas disponibles
APP for iPad devices:
1.- Download the APP from the Apple Store on your device by searching for 'dsppro v2'.
2.- Install the APP on your iPad.
3.- Once installed, the following icon will appear in your application panel
CONNECTION
In order to be able to control, configure and customise all the devices in the system you must have all of
them connected to the same LAN network through their RJ45 ports.
in star, with a SWITCH or ROUTER as the central node of the star. This equipment must be PoE to power
the NMX-WP, MCMD-1 and TAB-10-16 devices (it can also be powered by its power adapter.). All devices
work with static IP addresses, so DHCP is not necessary. Only TAB-10-16 has network configuration via
DHCP in addition to static (recommended).
IMPORTANT: it is recommended to review and configure IP addresses each time you connect a new device
to avoid network conflicts.
All devices are configured with a static IP and must be configured to connect to the same network.
This section explains how to make the necessary settings to configure the network on each device.
CABLE CONNECTION OF DEVICES TO THE NETWORK
In this section we will explain the ports to connect the equipment to the network by cable. PC/Mac and
TAB-10-16 displays, tablets and iPads can be connected to the network via Wi-Fi.
It is recommended to use a quality router or switch and Cat 5e or better cables, so that communication
between devices is not compromised and audio signals can be transmitted with as little delay as possible.
-
Connect your PC/Mac to the network via the Ethernet port.
-
Connect the matrix(ces) to the network. Note that if the matrix is DANTE, you must make at least 2
connections, the ethernet port of the matrix and the PRIMARY port of the Dante card. It is also
recommended to use a second network to connect to the SECONDARY port of the Dante card creating
redundancy so that if the first network has a communication failure, this second network will be able to
keep the signal running normally.
-
Connect the NMX-WP remote control via its LAN port. This connection requires PoE.
-
Connect the TAB-10-16 via its ethernet port. This connection requires PoE or connect the power adapter.
Connect the MCMD-1 via its ethernet port. This connection requires PoE.
-
PC + SW
AUDIO MATRIX NMX-88D
Dante PRIMARY
MATRIX - NMX-88/88D/1616/1616D
1 V DC
1.5A
*
LAN
SWITCH
PoE / No PoE*
PoE
PoE
- 3 -
.
. The connection will always be made
TAB-10-16
NMX-WP
EN
MCMD-1
Publicidad
