5.- Once the screens have been designed, to load them into the device's APP, click on the
pop-up window will show the active devices.
6.- Select 1 or more by checking/unchecking the tick on each of the lines, click on the SYNC button to
synchronise and wait a few seconds until the process is fi nished. A % bar will indicate the progress of
the charge and show
IMPORTANT: it is recommended to save all designed screens on your PC and synchronise only when
you are sure, as it is not possible to revert the changes or download the fi le from the screen to the PC.
CONNECT MCMD-1 MICROPHONES
The MCMD-1 Dante microphone is a microphone that can only be used if one of the matrices in the installation
is Dante, as it will need a free Dante channel to broadcast its signal. For confi guration it will be necessary to
download and install DANTE CONTROLLER software available from the offi cial Audinate website.
As with the rest of the devices, we must make sure that it has the correct network confi guration, but as it is
not a device that is confi gured using the SW, we must use another method.
In order to detect a microphone with the PC software, the following aspects must be taken into account:
-
The MCMD-1 microphone will use a Dante channel of an NMX matrix so this matrix must be connected
to the correct IP address.
-
PC, microphone and matrix must be on the same LAN network.
1.- Install and run the Dante Controller software on your PC. When loading this software, you can check
the equipment it detects in the ROUTING tab.
NOTE: these devices shall only be those that are confi gured on the same network and subnetwork.
2.- To review the network confi guration, go to the DEVICE INFORMATION tab and a list of all devices
detected on the physical network, whether or not they are confi gured on the same network, will be
displayed. This list will highlight in red all devices that are not on the same network as your PC and will
display their IP address.
when it has been completed.
- 9 -
EN
icon and the