Publicidad
Idiomas disponibles
Idiomas disponibles
4
PRODUCT INSTALLATION
INSTALLATION STEPS
1. Install the electric bidet seat
1. Remove the existing toilet seat.
(a) Remove the toilet seat mounting bolts.
(b) Remove the existing toilet seat from the toilet.
Screw
Half spherical
washer
Sliding washer
Nut
2. Inser
ated rubber tube set into the
mounting holes on the toilet bowl.
Inflated tubes
Mounting holes
xed Card on the toilet bowl where
the mounting holes are. Make sure that the wash
/ dry gates are close to the rim and pointed
down.
Existing seat
Twist to loosen
Edgefold
4. Install the Catch Plate
(a) Cover with a metal washer.
(b) Place the ceramic catch plate in a rectangular
box vertically centered on the mounting paper
card.
(c) Cover with metal adjusting sheet.
(d) Tighten the screws using the large screws.
The
sign should point towards the back of the toilet
Sign on the catch plate.
Rectangular space
5. Install the electric bidet seat
(a) Remove Fixed Card.
(b) Press the push rod button and slide the seat
into the Catch Plate.
(c) Adjust the position of the seat and loosen the
screws to adjust position, if necessary.
Slide seat towards
back of toilet
09
Screw
Adjustment
plate
Catch plate
Metal Washer
Push rod button
Publicidad
