Publicidad
Idiomas disponibles
Idiomas disponibles
2
UNIT & PARTS
Sizing Requirements
Please measure your toilet to make sure that there is enough space for the bidet (20.4in long).
The distance between the 2 mounting holes must be within 4.72-6.89in.
T
The distance between the mounting holes and the edge of the toilet bowl must be within
17.99-19.72in.
※
The product has no Ground Fault Circuit Interrupter. It should be installed in the line with
Ground Fault Circuit Interrupter. Otherwise, the accidental failure of this product may result in the
loss of life or property.
Installing the remote
1. Drill a hole on the appropriate position in the wall;
2. Paste the remote control hanger with double-sided tape;
Fix the remote control hanger on the wall with expansion screws and cover the silicone plug;
4. Insert the remote control on the rack.
Note:
The size of expansion screws and drill bit shall be subject to actual measurements.
4.72-6.89in
or less.
within 23.62in
17.99-19.72in
Remote control
Expansion screw
Remote control hanger
Expansion screw silicone
07
Publicidad
