Tognana D2DTU03IRZU Manual De Usuario página 18

OPERATING PRINCIPLE
The appliance is intended to blend vegetables, meat and cheese.
HAZARD! Do not blend particularly hard foods such as ice
cubes, nutmeg, coffee beans and cereals.
The blades are very sharp! Exercise extra caution when handling
the blades!
1. Before use, all parts that come into contact with the foodstuffs must be cleaned. Use detergent
and water to clean the lid, the blades and the food blender container. Use a soft cloth to clean
the motor unit.
2. Place the the food blender bowl on a flat surface.
3. Secure the main blade unit in the shaft,
then pour in the food to be blended, taking
care not to exceed the MAX level indicated
on the container. Hard food must be cut
into pieces (about 2 cm). Otherwise, the
motor may seize.
Note: this appliance is supplied with two sets
of blades. Check that the two sets of blades
are properly installed on the blade shaft. Do
not over-tighten. The two sets of blades must
be installed as shown in the figure on the right.
4. Place the lid on the container turning it clockwise until the two parts lock together. Place the motor
unit on the lid of the food blender.
5. Connect the appliance. Press the power button to start processing.
Note: Start processing with pulse movements, rapidly pressing and releasing the power button until
obtaining the desired consistency. After placing the food in the container, if the blades are not
working properly disconnect the unit and remove some of the food, then continue.
6. After use, disconnect the appliance and wait for the blade to come to a complete stop. Remove the
motor unit, the removable lid and the blades.
Note: Always check that the motor unit is in position, otherwise it will not work.
7. After use, disconnect the appliance from the power supply and remove the motor body with a
counter-clockwise motion. Remove the lid, the blade assembly and food, then clean as described in
the section, "CLEANING AND MAINTENANCE".
If food builds up around the blades during use:
1. Release the power button and wait for the blades to completely stop.
2. Remove the motor unit and processing lid.
3. Use a spatula to carefully remove the food. Do not use your fingers because the
blades are sharp!
4. Once the food has been removed and the blades cleaned, refit the processing lid
and motor unit and continue processing.
18