Publicidad
Idiomas disponibles
Idiomas disponibles
A
K2
CLEANING
1. Switch off the pole saw and remove the battery.
2. Do not use aggressive detergents or solvents. Clean the machine after use with a damp cloth dipped in
mild detergent.
3. Keep battery connection free of dirt and debris, and clean with a soft and dry brush or cloth.
4. Do not spray water onto the motor and electrical components.
5. Do not use pressure washer to clean your machine.
STORAGE
1. Remove the battery pack from the pole saw before storage.
2. Store the pole saw and the battery in a dry and secure place that is inaccessible to children and other
unauthorized people.
3. If the saw gets wet in the rain during operation, the machine and the battery pack should be dried before
storing or charging.
TROUBLESHOOTING
The following table gives checks and actions that you can perform if your machine does not operate correctly. If
these do not identify/remedy the problem, contact your service agent.
WARNING: Switch off and remove the battery pack before investigating fault.
Symptom
Pole saw fails to
operate
Pole saw
operates
intermittently
Dry chain
Possible Cause
Battery depleted
Over heating
Applying too much pressure while
cutting.
Loose connection.
Internal wiring defective.
On/off trigger defective.
No oil in oil tank
Vent in oil fill cap clogged
Oil passage clogged
Remedy
Charge the battery pack
Place the machine in a cool, ventilated
place to cool it down
Apply less pressure while cutting
Contact your service agent.
Refill oil
Clean cap
Clean oil passage outlet
EN
15
Publicidad
